Would you like to react to this message? Create an account in a few clicks or log in to continue.

sweep modifier problem

 :: General :: Help Line

Go down

sweep modifier problem Empty sweep modifier problem

Post by korngrain69 on Thu Aug 20, 2015 7:37 am

need help sa sweep modifier mga cgpians, original spline sa left side, pag sweep ko iba lumalabas and looks twisted siya and flat. na try ko na ata lahat wala parin good result. thank you po.cornice po ginagawa ko.sweep modifier problem Untitled-1_zpsbwwsfdyp" />
korngrain69
korngrain69
CGP Apprentice
CGP Apprentice

Number of posts : 824
Age : 70
Location : hanapin mo ako!
Registration date : 18/12/2008

Back to top Go down

sweep modifier problem Empty Re: sweep modifier problem

Post by insight on Thu Aug 20, 2015 10:14 am

Hi Sir, try niyo po e reset xform nang spline niyo.. at try niyo din gumamit nang bevel profile.

insight
CGP Newbie
CGP Newbie

Number of posts : 28
Age : 68
Location : Somewhere Out there
Registration date : 27/06/2015

Back to top Go down

sweep modifier problem Empty Re: sweep modifier problem

Post by korngrain69 on Fri Aug 21, 2015 11:36 pm

Thank you sa info sir, ganoon parin kahit na reset ko na yung xform. traced ko nalang ulit yung profile ng cornice, pero sa front view na siya. ok na ngayon sir, salamat.
korngrain69
korngrain69
CGP Apprentice
CGP Apprentice

Number of posts : 824
Age : 70
Location : hanapin mo ako!
Registration date : 18/12/2008

Back to top Go down

sweep modifier problem Empty Re: sweep modifier problem

Post by BuffBaby on Sun Aug 23, 2015 8:19 pm

your spline should be on the same plane

try creating a spline from top view first then apply sweep modifier

see if this works
BuffBaby
BuffBaby
CGP Apprentice
CGP Apprentice

Number of posts : 348
Age : 38
Location : manila
Registration date : 05/08/2009

Back to top Go down

sweep modifier problem Empty Re: sweep modifier problem

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top


 :: General :: Help Line

 
Permissions in this forum:
You cannot reply to topics in this forum