Dark Spots on Curves

Ano po ba fix nito blotches almost tried everything sa mga tuts pero same results parin po nakukuha ko. Kahit palitan ko ang material same po ang results.

try mo yong UV MAP na modefier sir,,, as  one whole group... mawawala yan sir...

splotches means, kulang ang light na narereceive, then 2nd is low ang subdivs mo, try mo change yung value sa adaptive image sample under v-ray... Min subdivs=5 max subdivs=20.

additional tips - lagyan mo ng artificial lighting infront dun sa may dark spots like rectangular light with minimum intensity try lang...

1. be sure na yung normals were not flipped.
2. apply smooth modifier sa mga ginamitan mo ng bevel profile (check auto smooth)
3. make sure you apply correct uvw map



update us if these steps works so everybody will know  good luck!

Thanks sa help mga boss.

Problem was the model, it is imported from sketch up. Doble ang faces ng curves fix it using bevel profile remodeling the doors sa max mismo. Then I got the results I want. Thankssss Thanksss Thanksss.

nice one sir nakita you din ang problem....minsan kasi nangyayari talaga yan.but its a lesson.comment ko lang sa counter top nya is mas maganda kung mapapalitaw mo pa ang marble nya ng mas maganda.kasi very light siya